PHILIPS 32PW8506/58 EM2E niebieskie tło

Hammer111 wrote:

Witam. Nie chciałbym się wymądrzać ale jeżeli TV pracuje na kineskopie ESF to niestety kineskop do wymiany. W tego typu TV a zwłaszcza 32 calowe to już standard. Proszę w wyszukiwarkę wpisać ESF i poczytać posty na temat tego typu kineskopów.Pozdr.

Quote:

The Service Alignment Mode (SAM). In this mode items of
the set can be adjusted via a menu and with the help of test
patterns.

Via the blinking LED procedure. The contents of the error
buffer can also be made visible through the “blinking LED”
procedure. This is espeсially useful when there is no
picture. There are two methods:
– When the SDM is entered, the LED will blink the
number of times, equal to the value of the last (newest)
error code (repeatedly).
– Via the 'DIAGNOSE' key of the DST. If an error has
been detected by the EM2E chassis, the set might go
into protection. Without the presence of a picture, the
errors can be displayed via the red LED on command
of the DST, as long as the main-processor is still active.
To display the errors via the red LED by the DST:
1. Press the 'DIAGNOSE' key (in all modes except
the SAM).
2. Press '1' to view the last error detected (or '2', etc.
to show the errors before).
3. Press the 'OK' key. The blinking Red LED on the
TV will now give the requested error.
Example:
Error code position 1 - 2 - 3 - 4 - 5
Error buffer: 12 - 9 - 5 - 0 - 0
After entering SDM: blink 1x long (750 ms for tens)
- pause (1.5 s) - blink 8 x short (250 ms for units) -
etc.
After transmitting 'DIAGNOSE-2-OK' with the DST:
blink 9 x short - pause (250 ms) - blink 9 x short -
etc.
After transmitting 'DIAGNOSE-3-OK' with the DST:
blink 5 x short - pause (250 ms) - blink 5 x - etc.
After transmitting 'DIAGNOSE-4-OK' with the DST:
nothing happens