logo elektroda
logo elektroda
X
logo elektroda
Adblock/uBlockOrigin/AdGuard mogą powodować znikanie niektórych postów z powodu nowej reguły.

drugi pilot do chrysler t&c

Knoris 02 Lis 2008 13:30 3087 8
  • #1 5693159
    Knoris
    Poziom 11  
    Witam
    jak dodać drugi pilot do oryginalnego alarmu chryslera?
    proszę o pomoc posiadam od niedawna chryslera otrzymałem do niego oryginalny pilot oraz drugi sprzedawca mówił ,że będzie działał tylko trzeba dodać:( ale jak to tego nie wiedział.
    Na oryginalnym jest napisane:
    model/fcc id G043VT18T
    canada 147 010 21507
    na drugim
    model/fcc id G043VT9T
    canada 1470 102 460
    można go dodać jeżeli tak to jak :|
  • #3 5693624
    pkhenr
    Poziom 32  
    Może tak

    CHRYSLER / JEEP
    96 Concorde, Intrepid, LHS, New Yorker, Vision Remote Programming
    1. Turn Ignition ON.
    2. Connect a jump wire from Pin 1 of the Diagnostic Connector (Upper left
    pin is number 1). Connect to ground.
    3. Doors will LOCK and then UNLOCK to verify program mode.
    4. Press the button on the remote control, doors will LOCK and UNLOCK to
    verify programming is complete.
    5. Repeat for additional transmitters.
    6. Remove wire and turn ignition OFF.
    7. Test all remote controls.
    Programming this type of Remote control
    1. Open the drivers door and leave open.
    2. Turn the mechanical door lock lever on the drivers door to LOCK.
    3. Insert Ignition key and turn ignition ON.
    4. Point the transmitter at the receiver and press the LOCK button for 5 seconds.
    If successful the door will unlock.
    5. Additional remotes can be programmed by moving the lock lever back to
    the lock position and perform procedure 4 again.
    6. Repeat for up to 4 remotes.
    7. When completed turn ignition OFF and ON within 20 seconds of programming
    the final remote control.
    8. Check all remotes for operation
  • #4 5693835
    Knoris
    Poziom 11  
    rok 2002 , a nie ma jakiejś prostej metody np 6Xprzekręcanie zapłonu, czy coś podobnego?
  • #5 5693927
    mr-perch
    Poziom 29  
    Znana mi procedura wymaga pięciokrotnego włączenia zapłonu w czasie 2 sekund. Nie wiem, czy dla kolegi Knoris jest to wystarczająco proste działanie? Zawsze można prosić producenta o uproszczenie tego, co już wymyślił.
  • #7 5695920
    mr-perch
    Poziom 29  
    Ale ja przecież nie podałem pełnej procedury programowania.
  • #8 5696159
    Knoris
    Poziom 11  
    a więc...
REKLAMA