Thank You !
I tried all the variants and it still does not work.
The controller is programmed, it has quartz oscillation, IR receiver is ok, ok links.
Is there a possibility that the firmware is not loaded to the correct address?
If you're sure that mcu is good, then perform troubleshooting with driver, like a high state on pin 8: MOTON should make hdd motor spinning,
as well just after power on, mcu should have high state on pin 51.
It's hard to guess, check connections, or vias, cold/dry solder joints, if you have spare mcu or driver, try to replace.
I'm using avrdude for flashing mcu, no need to change address, just a simple command like:
Zaloguj się, aby zobaczyć kod
Potrafisz napisać podobny artykuł? Wyślij do mnie a otrzymasz pendrive 32GB.