logo elektroda
logo elektroda
X
logo elektroda
REKLAMA
REKLAMA
Adblock/uBlockOrigin/AdGuard mogą powodować znikanie niektórych postów z powodu nowej reguły.

Drukarka HP Color Laserjet 2500L

jawik40 26 Lut 2011 12:48 1717 2
REKLAMA
  • #1 9206314
    jawik40
    Poziom 9  
    Witam. Chciałem uzupełnić proszek w tonerach w drukarce HP lj2500L na czterech bębnach .Service pokazuje mi za jest bardzo mała ilość a niebieskiego nie ma wogole.Czy może ktoś wie jak to zrobić by nie uszkodzić tonera?A przy uzupełnieniu tonerów czy potrzebna jest wymiana CHIPA.Z góry serdecznie dziękuje za podpowiedz.
  • REKLAMA
  • #2 9206489
    ABLublin
    Specjalista - kserokopiarki
    Miła lektura tu : instrukcja

    Wymiana chipa jest konieczna
  • #3 9208797
    pawcio24
    Poziom 20  
    wyczyść wklad po starym tonerze zasyp nowym proszkiem potem cytat

    "from service manual:
    To perform a NVRAM init
    1 Turn the printer off.
    2 Press and hold the GO button.
    3 Turn the printer on and continue to hold the GO button.
    4 After the Go, Ready, and Attention LEDs turn on, continue holding for at least 20 seconds.
    During this process, the Attention, Ready, and Go LEDs will each turn off.
    5 Release the GO button.
    6 The device LEDs will begin cycling from front to back. The NVRAM-init process runs until the
    printer is in the Ready state.

    see service manuals on www.sm.copyprofi.net"

    nara
REKLAMA