Witam
Mam taki problem. Ściągnąłem sobie AVR Studio 5 i nie mogę uruchomić
debuggera, mimo że kod jest prawidłowy ( nie zgłasza żadnych błędów).
Po assemblacji (używam assemblera) wywala następujący komunikat:
**********
AVR Studio was unable to start your debug session.
Please verify that the debugger is correctly attached to the target and that target power has been switched on. Also verify that the correct device and interface settings have been specified in the project.
**********
Jestem kiepski w angielskim.
Czy ktoś będzie tak uprzejmy mi pomóc i oświeci, o co tu chodzi? Tłumacz Google nic mi nie rozjaśnił.
Pozdrowienia
Mam taki problem. Ściągnąłem sobie AVR Studio 5 i nie mogę uruchomić
debuggera, mimo że kod jest prawidłowy ( nie zgłasza żadnych błędów).
Po assemblacji (używam assemblera) wywala następujący komunikat:
**********
AVR Studio was unable to start your debug session.
Please verify that the debugger is correctly attached to the target and that target power has been switched on. Also verify that the correct device and interface settings have been specified in the project.
**********
Jestem kiepski w angielskim.
Czy ktoś będzie tak uprzejmy mi pomóc i oświeci, o co tu chodzi? Tłumacz Google nic mi nie rozjaśnił.
Pozdrowienia
