Elektroda.pl
Elektroda.pl
X
Elektroda.pl
Proszę, dodaj wyjątek dla www.elektroda.pl do Adblock.
Dzięki temu, że oglądasz reklamy, wspierasz portal i użytkowników.

PIONEER/PDP434PE - Pioneer PDP434-PE, MediaBOx PIONEER R05XE(RESET TRAP) BLOKAda

1error1 25 Mar 2014 20:25 1929 0
  • #1 25 Mar 2014 20:25
    1error1
    Poziom 1  

    Witam jestem nowy, wiec sory za jakiekolwiek bledy na forum(itd,itp)
    Problem mam z Telewizorem Pioneer PDP434-PE i Media Box PDP-R05XE.
    Przeszukujac internet doczytalem ze po zdjeciu obudowy z wyzej wymienionych sprzetow wlacza sie blokada tzw. "TRAP"(niestety zdjalem obudowe) moje pytanie brzmi jak mam pozbyc sie tej blokady Pilot jaki posiadam to AXD1509 Pioneer.?
    Swieca sie dwie diody czerwona i zielona po wlaczeniu owych sprzetow.
    PROSZe o Pomoc :?: :cry:
    Znalazlem w instrukcji takie informacje ale nie rozumiem kompletnie nic z tego.
    7.1.4 CANCELING DETECTION BY THE TRAP SWITCH
    Outline: For video data transmission from the Media Receiver to the plasma display, digital signals are used. Therefore, this unit adopts
    the HDCP (High-bandwidth Digital Content Protection) system for copyright protection. This unit is also provided with a
    detection switch (TRAP switch) that will prohibit the unit from being turned on again if the rear case of the unit is opened, in
    order to prevent the panel technology from being leaked out.
    Function: To deactivate the detection of the TRAP switch
    Purposes: 1. During production of this unit, adjusting with the rear cover opened is possible.
    2. During servicing or repairing, diagnoses of the assemblies are possible while the power is on.
    Methods: For setting, use RS232C commands:
    TSN: Ignore the monitoring of the switch
    CTM: Clear the detection log of the switch
    TSY: Reactivate monitoring of the switch
    Notes:
     The TRAP switch is located on the chassis (see Fig. below).
     Once rear case opening is detected, send the TSN and CTM commands.
     Because the TSN command is not stored in memory, monitoring of the switch can be reactivated by turning the unit off then back on.
     The same setting is possible using the Factory menu.
     Because the output of the DVI receiver is controlled by the physical setting of the TRAP switch, if the TRAP switch is set to OPEN, the DVI
    signal cannot be output even if the TSN command is sent.
     When the Media Receiver is connected, detection by the TRAP switch can be canceled by entering Factory mode.
     Canceling detection by the TRAP switch
     How to enter Factory mode using the remote control unit
    Please refer to the technical documentation (Service knowhow).
     How to clear the detection log of the TRAP switch
    In the INITIALIZE layer, hold the OSD key on the remote control unit pressed for at least 3 seconds.
     After a power-down, to cancel detection of the TRAP switch using only the remote control unit, follow the
    procedures below.
    First, fix the TRAP switch to its depressed position. Set the drive ON/OFF switch in the DIGITAL VIDEO Assy to OFF,
    Then enter the Factory mode. Press the MUTE key four times, then hold the OSD key pressed for at least 3 seconds. Set the AC switch on
    the panel to OFF. The log is also cleared. Then set the drive ON/OFF switch to ON


    krotki filmik mozna znaleźć na youtube pod nazwą "Reset TRAP"

    0 0