logo elektroda
logo elektroda
X
logo elektroda
REKLAMA
REKLAMA
Adblock/uBlockOrigin/AdGuard mogą powodować znikanie niektórych postów z powodu nowej reguły.

Błąd drukarki HP Photosmart C6180 C5180 0xc18a0106

AB 28 Cze 2015 08:41 10062 2
REKLAMA
  • Aby skasować błąd drukarki 0xc18a0106 należy zresetować drukarkę.

    Procedura resetu drukarki:

    1 Odłącz kabel USB od drukarki.
    2 Naciśnij przycisk ON / OFF, aby wyłączyć drukarkę, odłącz przewód zasilający od drukarki, naciśnij i przytrzymaj przyciski "OK" i przycisk "Pomoc", a następnie podłącz kabel zasilania, odczekaj kilka sekund i zwolnij oba przyciski, a następnie naciśnij przycisk "ON".
    Drukarka będzie teraz zainicjować się i trzeba postępować zgodnie z instrukcjami wyświetlanymi na ekranie. Może to potrwać kilka minut. Twój kod błędu powinien teraz zniknąć i będzie już można drukować.
    3 Podłącz ponownie kabel USB od drukarki.
    O autorze
    AB
    Poziom 17  
    Offline 
    AB napisał 273 postów o ocenie 38, pomógł 9 razy. Mieszka w mieście Terespol. Jest z nami od 2002 roku.
  • REKLAMA
  • #2 15019997
    CMS
    Administrator HydePark
    Orientujesz się może jak jest procedura resetu przy tym samym błędzie w drukarce Photosmart D7160 przy tym samym błędzie? Nie widzę tu przycisku, który mógłby być "przyciskiem Pomoc".

    Pozdrawiam.
    CMS
  • #3 15026244
    AB
    Poziom 17  
    Ten błąd to problem z tuszami bądź z głowicą drukującą.
    Odwiedź poniższy link:
    http://support.hp.com/es-es/document/c03081973

    Step 1: Reset the printer
    Without turning off the printer, disconnect the USB cable from the rear of the printer.
    NOTE:
    The USB cable connects to the port on the rear of the printer. The port is labeled with the USB icon (). If your printer has a network or wireless connection, ignore this step.
    Figure : Example USB connection (your printer might not look exactly the same as this example)
    Description of disconnecting the USB cable.
    Remove the ink cartridges from the printer.
    Wait until a message to insert the ink cartridges displays. If you do not see a message within a few minutes, skip to step 4 to disconnect the power cord.
    NOTE:
    If your printer does not have a control panel, wait until the ink cartridge lights blink. If the ink cartridge lights do not blink within a few minutes, skip to step 4 to disconnect the power cord.
    Disconnect the power cord from the rear of the printer.
    Wait 60 seconds.
    Reconnect the power cord. If the printer does not automatically turn on, press the Power button.
    Reinsert the ink cartridges, and then close any open doors on the printer.
    If you receive a prompt to print a calibration page, do so.
    If you disconnected the USB cable, reconnect it to the rear of the printer.
    Try to print
REKLAMA