Please add exception to AdBlock for elektroda.pl.
If you watch the ads, you support portal and users.

kodowanie kluczyka start/sop corolla verso

jablonski1 15 Apr 2017 18:24 4359 2
  • #1
    Level 9  
    Pomóżcie proszę jak na nowo zakodować kluczyk. Dzisiaj zarówno 1 jak i 2 kluczyk ma wymienione baterie, świeci się lampka czerwona i ni hu hu samochód się nie zamyka i nie otwiera na centralnym zamku.

    Samochód ma system start/stop .
  • #3
    Level 43  
    Begin with:

    The driver’s door open and unlocked.

    Key out of the ignition.

    1. Insert and remove the key from the ignition switch 2 times within 5 seconds.


    Steps 2 and 3 should be performed within 40 seconds.

    2. Close and open driver’s door TWICE.

    3. Insert the key into the ignition and remove it.


    Steps 4 – 6 should be performed within 40 seconds.

    4. Close and open the driver’s door twice.

    5. Insert the key into the ignition.

    6. Close the door.


    Steps 5 and 6 should be reversed for the following models ONLY (close door first,

    then insert key into ignition):

    2000 – 2005 Celica

    2001 – 2003 Prius

    2001 – 2005 ECHO

    2001 – 2005 RAV4

    2003 – 2004 Avalon

    7. Turn the ignition switch from “Lock” to “On” and back to “Lock” at about 1 second

    intervals to select the desired mode:

    1 time for ADD mode.

    2 times for REWRITE mode.

    3 times for CONFIRMATION mode.

    5 times for PROHIBITION mode.

    8. Remove the key from the ignition.

    9. To confirm your mode selection, the power locks will now cycle “lock” to “unlock” a

    number of times corresponding to your key cycles in step 7.

    NOTE: If Confirmation or Prohibition modes have been selected, opening the door will

    complete the procedure.

    10. For Add or Rewrite modes do the following within 40 seconds of Door

    Lock confirmation:

    A. Press both transmitter Lock and Unlock buttons simultaneously between 1 and

    1.5 seconds and release.

    B. Within 3 seconds of step A, press the transmitter Lock button for more than 1

    second and release.

    NOTE: If the transmitter has been successfully programmed, the power locks will

    cycle “lock” to “unlock” once at this time. If there are problems with the transmitter or the procedure up to this point, the locks will cycle twice. If this occurs, verify that you have received the correct transmitter, and then repeat the above procedure.

    C. If multiple remotes are to be reprogrammed, repeat steps A and B.

    11. Open the driver’s door to conclude programming mode.