Ah right. Got it. I will try few different cards. Just in case.
Ranko
Dodano po 11 [minuty]:
Wooohoooo!!! Sucsess!!!!
So not all SD cards are made equal... not a big news... This 4GB card works for me. This is the same card I was using for programming DIY in the first place.
Here is the preview of the case. This is not final design. Now I am implementing some improvements suggested by Piotr.
We are days away from production. Any preference in terms of colour and finish for the case?
Btw, site https://www.diy-a586.com is progressing well. I will expedite development so we can have one place where people can get support, license keys, claim warranty if needed and finally purchase boards, cases, power supplyes etc..
Perhaps getting healty stock of PS/2 keyboards and mouses is not a bad idea. Also we will try to keep prices lowest possible so everyone can afford assembled boards.
Since board is "open design" we will also make sure everything is available as DIY kit - Case design, component locator, software, precise component specs etc...
Jeden z egzemplarzy skręciłem czymś takim. Wysokość 47mm. Muszę tylko boki wydrukować.
Z kawałka laminatu zrobiłem płytkę łączącą stację dyskietek z "płytą główną".
Do laminatu zostały przylutowane mosiężne gwintowane dystanse.
Spód wydrukowany 3d.
Cześć
Co prawda płytkę mam już strasznie długo (od Amiparty), ale ostatnio coś mnie zmotywowało i polutowałem emulator Generalnie pierwsze odpalenie zaowocowało takim oto obrazem.
Czy przypadkiem nie powinno już coś być w menu na starcie?
Przed wlutowaniem flasha zaprogramowałem go plikiem main.
Pozdrawiam
Red