logo elektroda
logo elektroda
X
logo elektroda
REKLAMA
REKLAMA
Adblock/uBlockOrigin/AdGuard mogą powodować znikanie niektórych postów z powodu nowej reguły.

[Rozwiązano] Indukcja Gorenje it 606 ASC - Programowanie pól po wymianie, naprawie pola induk

darek22225 23 Lut 2020 18:21 2094 3
REKLAMA
  • #1 18489164
    darek22225
    Poziom 10  
    Witam
    Mam problem z płytą Gorenje IT 606 ASC . Lewe dolne pole wyświetla błąd e4 . Jestem po wymianie rezystora 39om 5 w i kondensatora elektrolitycznego 470uf 25v. W zasilaczu też wymieniłem kędziorki i przylutowałem zasilacz (przekaźniki - zimne luty).
    Dalej błąd występuje , co ciekawe zamieniając miejscami pola lewe dolne z górnym prawym ( maja te same wartości parametry, nic to nie daje.
    Pole nadal wyświetla błąd e4. A górne prawe jest sprawne w 100%.
    Nie mam już pomysłu poza przeprogramowaniem wszystkich pól, niestety nie znam procedury programowania tej płyty . Przeszukałem internet i nic nie znalazłem. Może ktoś z kolegów wie jak wejść w programowanie pól tej płyty?

    Numer pola modułu to: EGO75.08010.212.
  • REKLAMA
  • Pomocny post
    #2 18489680
    mrhari
    VIP Zasłużony dla elektroda
    Tu masz instrukcję poniżej. Pamiętaj by w razie braku sukcesu za każdym razem odłączać urządzenie od sieci i podłączać znów by ponowić.
    Opis jest po angielsku ale z googlami dasz radę.

    Spoiler:
    Configuring is necessary when changing the IHE (induction heating element), or when the display shows E4.
    Procedure is the following:

    Access to the configuration menu is possible within 2 minutes after connecting the appliance to the electric grid.

    Press and hold the sensor minus and in anti clokwise direction (starting with the sensor for the front right cooking zone) press one after another all cooking zones sensors. Each time you press it sounds a beep. It is necessary to press evenly and fairly quickly. If the acoustic signal sounds more than once, it is necessary to repeat the procedure (it is not necessary to disconnect the appliance from the mains).

    Display shows C for unconfigured cooking zones and "-" for configured ones.

    Now choose a cooking surface that you want to configure by pressing the corresponding sensor key. The symbol "C" flashes. In 20 seconds, it is necessary to place the container on the cooking zone, the display will show the symbol "-".

    This procedure must be carried out for each unconfigured cooking zone, after the last one is configured configuration menu will be automatically closed. Please note that in any case should not be while configuring two containers simultaneously on the induction plate.

    ATTN: how to reset the configuration?

    This requires pressing the minus key for at least 2 seconds which results in the symbol “E” to appear on all cooking zone displays. The “E” on the cooking zone displays continues flashing until all IHE´s have restored the initial state and changes into “C” right afterwards. The cooking zones may now be configure anew.
  • REKLAMA
REKLAMA