Witam.
Podczas próby sprawdzenia podłączonego AVR w programie MkAVR Calculator wyskakuje błąd:
avrdude.exe: set SCK frequency to 2000 Hz
avrdude.exe: warning: cannot set sck period. please check for usbasp firmware update.
avrdude.exe: error: programm enable: target doesn't answer. 1
avrdude.exe: initialization failed, rc=-1
avrdude.exe: AVR device initialized and ready to accept instructions
avrdude.exe: Device signature = 0x000000
avrdude.exe: Yikes! Invalid device signature.
avrdude.exe: Expected signature for ATMEGA8 is 1E 93 07
avrdude.exe done. Thank you.
Compiled special for http://forum.atnel.pl (v5.11.1)
Wszystko działało, ale ustawiłem wewnętrzny oscylator na 1MHz wtedy program przestał działać.
jak to naprawić w prosty sposób bez konieczności użycia innych programatorów, mam tylko USPAsp?
Podczas próby sprawdzenia podłączonego AVR w programie MkAVR Calculator wyskakuje błąd:
avrdude.exe: set SCK frequency to 2000 Hz
avrdude.exe: warning: cannot set sck period. please check for usbasp firmware update.
avrdude.exe: error: programm enable: target doesn't answer. 1
avrdude.exe: initialization failed, rc=-1
avrdude.exe: AVR device initialized and ready to accept instructions
avrdude.exe: Device signature = 0x000000
avrdude.exe: Yikes! Invalid device signature.
avrdude.exe: Expected signature for ATMEGA8 is 1E 93 07
avrdude.exe done. Thank you.
Compiled special for http://forum.atnel.pl (v5.11.1)
Wszystko działało, ale ustawiłem wewnętrzny oscylator na 1MHz wtedy program przestał działać.
jak to naprawić w prosty sposób bez konieczności użycia innych programatorów, mam tylko USPAsp?