logo elektroda
logo elektroda
X
logo elektroda
REKLAMA
REKLAMA
Adblock/uBlockOrigin/AdGuard mogą powodować znikanie niektórych postów z powodu nowej reguły.

Falownik Lenze 9400 HighLine Podnapięcie szyny DC BŁĄD NAPĘDU

myacine 11 Cze 2020 17:22 11289 2
REKLAMA
Treść została przetłumaczona angielski » polski Zobacz oryginalną wersję tematu
  • #1 18753308
    myacine
    Poziom 1  
    Cześć wszystkim.
    Mam problem 9400 highline falownik Lenze,
    Wystąpił błąd ,,Za niskie napięcie szyny DC" z odpowiedzią ,,Problem" w ,,Diagnostyce" ,,Inżyniera"
    jak mogę rozwiązać ten problem, wiedząc, że rzeczywiste napięcie szyny DC wynosi 563 V.
    o napięcie sieciowe jest OK
    o ustawienie w C00173 wynosi 285 woltów
    Jeśli to możliwe, szukam instrukcji obsługi lub naprawy Highline 9400
    Czy możesz mi pomóc naprawić ten błąd
    Wielkie dzięki

    Falownik Lenze 9400 HighLine Podnapięcie szyny DC BŁĄD NAPĘDU
  • REKLAMA
  • #2 18781542
    krzysiul
    Poziom 20  
    Try to measure DC voltage on UG+ and UG- terminals. When supplied (400V on L1-L2-L3) there should be ~565V DC.
    Then, in diagnostic (kepad or PC program "Engineer"/"Easy Starter") check the value of DC Bus shown (code C0053) - if there is 0V then you have probably a rectifier (or voltage measurment system) broken. In this case the inverter should be sent for a repair.
    If the value in C0053 is OK then check the setting in C0174 for monitoring the undervoltage (but if it was working earlier and there is mains, I would suspect an inverter damage)

    Best regards
  • #3 19222603
    qcw99a
    Poziom 1  
    To usterka sprzętu, musisz naprawić DriveBoard
REKLAMA