Dyna Mass Storage Tool v19.11.13.21 nie działa z flash ID 983C90B37671

Hi. Before, this version Dyna Mass Storage Production Tool v19.11.13.21 S1215.zip
Download
(57.08 MB) fixed my flash drive. But now my flash drive got damaged again. This tool is not working. Can I request for this version with flash ID 983C90B37671? Because before, my flash ID was 453C98B37671.




----
Wydzielono z tematu: Uszkodzony pendrive - zawiesza się i nie jest wykrywany
przez dt1 dnia 09 Kwi 2025 13:49

Semiconductor media failures are associated with NAND wear and degradation. Reprogramming repairs help eliminate firmware errors but cannot physically repair the device. As such, their effects are often short-lived.

If you want to know more, read this:
http://kaleron.pl/SSD-failure.php
This is written for SSDs, but the principle of operation of the circuits, the physics of writing and storing data, and the basis of failure are the same for all devices using Flash-NAND memory.

junioelektroda napisał:

Can I request for this version with flash ID 983C90B37671? Because before, my flash ID was 453C98B37671.

These are exactly the same systems, but produced by two different manufacturers - Toshiba (98) and Sandisk (45).

Thank you for your response. I already tried renaming 453C98B37671 to 983C90B37671 inside all files .ffw, .dbf, .set, .bin, but it's still giving bad block over setting.

Added after 2 [minutes]:

.DBF
@ 45 3C 98 B3 76 71 3D 10 03 09 05 06 00 8E 8E 8F 87 A8 00 00 00 00 28 0E 19 21 21 92 92 92 91 66 66 DB // SanDisk SDTNAIAMA-032G P1026 3D TLC

.SET
45,3C,98,B3,76,71_0=3508
A3508=Sandisk,128Gbit (3D BiSC2,16k,576Page),SDTNAIAMA-032G-0(Single_DG) Sandisk,128Gbit(3D BiSC2,16K,576Page),SDTNAIAMA-032G-0(Single_DG)=45,3C,98,B3,76,71,2,0,11,0,0,F,68,F0,19,52,1,0,0,60,60,1,0,1,1,2,30,3,0,FF,0,44,0,,,,,,

I want to know how to create 4 GB or 16 GB binaries like this. Can you help me? Or can someone help me?