Jak naprawić negatywny prąd w baterii Gericom EMC31J po resecie EEPROM?

Witam wszystkich, przepraszam za błędy, ale jestem włoski. Szaleję na laptopa bateria 14.8V 4000mAh na Gericom beetle kontroler BQ2060 EMC31J i EEPROM 24LC02B. Po zresetowaniu, napięcie jest 14,8, ale obecna jest negatywna, -15 lub -18. Czy program eeprom z plikiem z asus i 24C02 chip BQ2060, FCC4300 samo napięcie? Jaka jest różnica między symbolem i LION LACE? Dzięki

You could write it in English?

well. I have the battery 14.8V 4000mAh for Gericom model EMC31J with BQ2060 controller and EEPROM 24LC02B. After the reset, do not charge equally. There are 14.8 volts, but the current is found to be negative, -12 mA. I tried with a light bulb directly on the contacts of the cells, and turns on normally. What could it be? I found a file in the forum of an ASUS 14.8v battery with eeprom 24C02, BQ2060 and FCC4300. Can I program my eprom with this file or I risk burn everything? I wait. Thanks

Better not to program a strange damp.

Post your damp before reset and after reset. I'll check if everything is fine.

Ok. I attached you files as you told. I added the asus file too. I must tell you that I changed nr.2 battery cells because there are short circuit. Two cells changed not was propely the same, but them worked; look at the image in the attached. I will flashing the asus file. What do you think? I waiting for you. Best redards

Your damp is ok.
You must replace all the cells, because on the other cell you have large voltage differences. Voltages between sections of the package can not differ by more than 20 mV.